TERAND INDUSTRIES, INC.
MATERIAL
SAFETY DATA SHEET
SECTION
I · PRODUCT IDENTIFICATION
Product Name:
GUM REMOVER Formula:
Proprietary HMIS Rating (Based on Aerosol Conc.):
Product
Number: 240 Date Prepared: 01/01/05 D2 0-Minimal 1- Slight 2- Moderate
Product Type: AEROSOL Emergency Phone: (613) 996-6666 3- Serious 4- Extreme
Supplier's
Name: Terand Industries, Inc. Information Phone: (905) 238-4949 HEALTH: 1
FIRE: 0 REACTIVITY: 1
Supplier's
Address: P.O. Box 9947,
Ft. Lauderdale, FL 33310 Personal Protection : B
TDG: CONSUMER COMMODITY · ORM-D WHMIS: Class A; Class D - Div 2B
SECTION
II ·HAZARDOUS INGREDIENTS
CHEMICAL NAME CAS # %WT TWA/TLV LD 50 LC 50
1,1,1,2 Tetrafluoroethane 811-97-2 100 N/D N/D N/D
SECTION III · PHYSICAL DATA
Data Below
Based On Aerosol Concentrate Only:
Boiling Point: -
26.5° C
pH: N/A Vapor
Density(Air=1): 3.6 @ 25°C
Solubility In Water:
0.15 % @ 25°C Specific
Gravity (H2O=1)@25° C: 1.203
Appearance/Odor: Clear Colourless Liquid, Faint Ether- like
Odour
Data Below
Based On Total Contents:
Vapor Pressure of can (psig @20° C): 90
Total VOC %: 0 %
SECTION IV · FIRE AND EXPLOSION
DATA
Flash Point (of Concentrate Only): Will not burn Flammability (as per Flame
Projection Test): Non-Flammable
Spray
Extinguishing
Media: Foam, CO2,
Dry Media
Special Fire
Fighting Procedures: Wear self-contained breathing apparatus and protective
clothing. Cool fire exposed containers to prevent rupturing.
Unusual Fire
and Explosion Hazards: Exposure to
temperature above 50° C may cause bursting.
SECTION V · REACTIVITY DATA
Stability: Material Stable. Hazardous Polymerization: Will not
Occur.
Incompatibility: Avoid contact with strong oxidizing agents.
Hazardous
Decomposition Products: Carbon
Dioxide, Carbon Monoxide.
SECTION VI · STORAGE AND HANDLING
KEEP OUT OF
REACH OF CHILDREN.
For Industrial and Institutional use only.
Store in a cool, dry area away from heat or open flame.
Do not store at temperatures above 50° C . NFPA Code 30B Rating: Level 1 Aerosol.
SECTION VII · HEALTH AND FIRST
AID
PRIMARY ROUTES
OF ENTRY & EFFECTS OF OVER EXPOSURE:
Eyes: May cause slight irritation but does not injure eye tissue.
Skin: Frequent or prolonged contact may cause irritation.
Inhalation: Inhalation of mist can cause irritation of nasal and
respiratory passages. Abusive or excessive inhalation may cause irritation to
the upper respiratory tract, dizziness, nausea and other central nervous system
effects.
Ingestion: Can cause gastrointestinal irritation, nausea, vomiting and
diarrhea. Aspiration of material into the lungs can cause chemical pneumonitis.
Minimal toxicity.
Carcinogenicity:
Non Hazardous by WHMIS
Criteria; Reproductive Effects - N/D;
Teratogenicity - N/D; Mutagenicity
- N/D; Synergistic Materials - N/D
FIRST AID
PROCEDURES:
Eyes: Flush with large amounts of cool running water for at least
15 minutes while holding upper and lower lids open. If irritation persists get
medical attention immediately.
Skin: Wash with soap and water. If irritation persists seek
medical attention.
Inhalation: Remove to fresh air. Seek medical attention immediately. If
breathing stops give artificial respiration.
Ingestion: Do not induce vomiting. Seek medical attention immediately.
SECTION VIII · SPECIAL PROTECTION
DATA
Respiratory
Protection: None needed for
proper use in accordance with label directions.
Ventilation: Provide local exhaust to keep TLV of Section II ingredients
below acceptable limits.
Protective
Gloves: None needed for
proper use in accordance with label directions. Use chemical resistant gloves
if hand contact will be made.
Eye
Protection: None needed unless it
is anticipated that a splash or spray back will occur, then wear safety glasses
or chemical proof goggles.
SECTION IX · SPILL OR LEAK
PROTECTION
STEPS TO BE
TAKEN IN CASE OF SPILL OR LEAK: Allow
propellant to evaporate. Maintain local exhaust and adequate ventilation. No
smoking. Keep sparks, heat sources and open flame far away from spill or leak.
Cover with absorbent material and sweep up. Wash area to prevent slipping.
Dispose of soaked absorbent material in accordance with Federal, Provincial and
local laws.
WASTE DISPOSAL
METHOD: Aerosol cans, when
emptied and depressurized through normal use, pose no disposal hazard and
should be recycled. Consult Federal, Provincial and local authorities for approved procedures.
N/A= NOT
APPLICABLE · N/E=NOT ESTABLISHED
· N/D=NOT DETERMINED ·
<=LESS THAN · >=MORE THAN
NOTICE: The information contained on this Material Safety Data Sheet
is considered accurate as of the date of publication. It is not necessarily all
inclusive nor fully adequate in every circumstances. The suggestions should not
be confused with, nor followed in violation of applicable laws, regulations,
rules or insurance requirements. No warranty, express or implied, of
merchantability, fitness, accuracy of data, or the results to be obtained from
the use thereof is made. The vendor assumes no responsibility for injury or
damages resulting from the inappropriate use of this product.